Pro-tools HMP-200 Bedienungsanleitung PDF herunterladen (Seite 6)

BENDING INSTRUCTIONS

TIGHTEN BOLT SO TUBE

WILL NOT SLIP

NOTE:

TO CALCULATE LENGTH OF TUBING USED IN A BEND,

MULTIPLY RADIUS OF BEND X 6.28 X DEGREE OF BEND,

THEN DIVIDE BY 360.

ABSOLUTELY NO GREASE IN RADIUS.

AT ALL TIMES TUBING, DIE RADIUS, AND

BAR RADIUS MUST BE CLEAN AND GREASE FREE.

TO MEASURE RADIUS:

START AT IMAGINARY CENTER OF CUTOUT, MEASURE TO EDGE OF DIE.

NOTE: ALL ROUND TUBE RADIUS MEASUREMENTS ARE “CENTER LINE RADIUS”

EXAMPLE:

8 INCH RADIUS, 90 DEGREE BEND WOULD BE;

8 x 6.28 x 90/360 = 12.56

PAGE 6

813-986-9000 Pro-Tools

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Pro-tools HMP-200 Bedienungsanleitung Seite 6