Pro-tools HMP-200 Bedienungsanleitung PDF herunterladen (Seite 7)

BENDING INSTRUCTIONS

813-986-9000 Pro-Tools

PAGE 7

THE NEXT FEW PAGES WILL SHOW YOU HOW TO DO A TEST BEND AND HOW TO INTERPRET THE

INFORMATION SO YOU WILL BE ABLE TO MAKE ACCURATE BENDS.

NOTE: FOR SAFETY’S SAKE WE STRONGLY RECOMMEND THAT YOU BOLT THE BENDER TO THE FLOOR

OR WORKBENCH BEFORE STARTING ANY BENDS.

STEP 1

THE TUBING FOR OUR TEST IS 1 3/4” x 36” LONG. ONLY ONE PIECE IS NECESSARY TO GIVE YOU ALL

THE INFORMATION YOU WILL NEED TO MAKE ACCURATE BENDS. IT IS A GOOD IDEA TO KEEP A

NOTEBOOK TO LOG YOUR INFORMATION ON THE TEST BEND. IT WILL BE NECESSARY TO RUN THE

SAME TEST FOR EACH SIZE TUBING YOU PLAN TO BEND.

NOTE: EACH SIZE OF TUBING BENDS AND STRETCHES AND USES A DIFFERENT AMOUNT

OF TUBING IN THE BEND, SO IT WILL BE IMPORTANT TO LOG THE RESULTS FROM EACH

TEST.

TAKE THE 36” PIECE OF TUBING & MEASURE FROM YOUR RIGHT BACK TO YOUR LEFT EXACTLY

12” & 24” AS SHOWN SO THERE WILL BE NO MISTAKING WHICH END IS WHICH AFTER YOU MAKE

THE BEND.

THE TUBING FOR OUR TEST IS 1 3/4” x 36” LONG. ONLY ONE PIECE IS NECESSARY TO GIVE YOU ALL

THE INFORMATION YOU WILL NEED TO MAKE ACCURATE BENDS. IT IS A GOOD IDEA TO KEEP A

NOTEBOOK TO LOG YOUR INFORMATION ON THE TEST BEND. IT WILL BE NECESSARY TO RUN THE

SAME TEST FOR EACH SIZE TUBING YOU PLAN TO BEND.

NOTE: EACH SIZE OF TUBING BENDS AND STRETCHES AND USES A DIFFERENT AMOUNT

OF TUBING IN THE BEND, SO IT WILL BE IMPORTANT TO LOG THE RESULTS FROM EACH

TEST.

STEP 2

INSTALL THE TUBING IN THE BENDER AND POSTION THE EDGE

OF THE DIE EXACTLY IN THE CENTER OF THE MARK AS SHOWN,

THEN MAKE A 90 DEGREE BEND. IN THIS EXAMPLE, WE ARE USING

A 1 3/4” x 7” TUBING DIE.

24”

12”

STEP 3

1 2 3 4 5 6 7 8 9 10

Keine Kommentare

Pro-tools HMP-200 Bedienungsanleitung Seite 7